Yitong 60-inch high-flow water filter produced is made of PP polypropylene. The pore size can be made between 1 and 100 microns according to customer requirements. The sizes are 10 inches, 20 inches, 30 inches, 40 inches. 60 inches, can completely replace the PALL filter element.
1. Five layers of filter media.
2. Adopting physical folding type, large medium area of filtration and high impurities removal.
3. PP polypropylene membrane meets the requirements of non-woven fabric and diversion layer to provide deep filtration structure
4. High physical pressure performance and stable filtration process
5. Good chemical compatibility , suitable to kinds of chemical filters.
Common uses: pre-filtration of RO reverse osmosis system
Chemical/petrochemical industry: various acids, bases, solvents, quench water, brine and other chemical agents
Power Plant: Supplementary Water, Condensate Water, Stator Cooling Water, etc.
General industry: various process fluids, process water, condensate, cooling water, wastewater treatment, etc.
Microelectronics industry: deionized water pre-filtration
Food and beverage industry: process water, etc.
filter element length: 20 inches (508 mm) 40 inches (1016 mm) 60 inches (1524 mm)
Outer diameter of filter element: 6.3 inches (160mm) inner diameter: 3.5 inches (89mm)
Maximum operating temperature: 80 C (0.1 mpa)
Maximum working pressure difference: 0.42 MPa (25 C)
Maximum replacement pressure difference: 0.2 MPa (25 C)
Pore size: 1,3,5,10,20,40,70,90,150 micron (micron)
Filter material: polypropylene
Supporting material: polypropylene
End cap material: reinforced polypropylene
Internal skeleton material: polypropylene
O-ring material: silicone rubber (default), ethylene-propylene rubber, nitrile-butadiene rubber, fluorine rubber, Teflon rubber.